Bellini CGH9501 Instrucciones de operaciones

20121211 issue 3 For warranty service call 1300 373 199(Australia) or 0508 123108(New Zealand) to connect you to the nearest authorised servi

Bellini – 60/90cm gas hob Rev: 8-9-2010 8 Then a particle board or similar heat baffle must be installed under the hob to prevent accidental touching

Bellini – 60/90cm gas hob Rev: 8-9-2010 9 For the Models CGH9501, BG604X and BG905X, light the Triple Ring and Auxiliary burner and adjust test point

WARRANTY 1.1 In this warranty: 1.1.1 Australian Consumer Law means the law as set out in Schedule 2 of the Competition and Consumer Act 2010; 1.1

1.8 You must provide proof of your purchase of the Bellini product and the date of purchase in order to obtain the benefit of this warranty. 1.9

Bellini – 60/90cm gas hob Installation and Operating Instructions Contents Page 1. IN

Bellini – 60/90cm gas hob Rev: 8-9-2010 1 1. INTRODUCTION AND SAFETY WARNINGS Congratulations on your investment in Bellini, quality stainless steel

Bellini – 60/90cm gas hob Rev: 8-9-2010 2 2. OPERATING INSTRUCTIONS LIGHTING THE BURNER The hotplates are fitted with mains powered electronic spark i

Bellini – 60/90cm gas hob Rev: 8-9-2010 3 3. CLEANING INSTRUCTIONS GENERAL Cleaning and maintenance should be carried out with the appliance cold espe

Bellini – 60/90cm gas hob Rev: 8-9-2010 4 4. TROUBLESHOOTING Servicing of the hotplates must only be done by an authorised service representative (see

Bellini – 60/90cm gas hob Rev: 8-9-2010 5 5. INSTALLATION IMPORTANT NOTE: Refer to the Warnings in Section 1 of these Instructions. This hotplate mus

Bellini – 60/90cm gas hob Rev: 8-9-2010 6 Model CGH9501: Bench cutout size, 830 mm wide x 473 mm deep. Bench top thickness, 30 – 40 mm (3 – 4 cm).

Bellini – 60/90cm gas hob Rev: 8-9-2010 7 Model BG905X: Bench cutout size, 830 mm wide x 472 mm deep. Bench top thickness, 30 – 40 mm (3 – 4 cm).